View Full Version : Drivetrain
- Drive shaft bolt
- Ford Racing Aluminum Driveshaft
- v6 rearend vs gt's
- pilot bearing?
- 8.8 Rear End on a V6
- Sweet!!! Look what i got today!
- quick question tranny mount help please!!!
- Ford racing told me 410's will tear up my V6!!!
- How to compensate for 410 gears and the spedo?
- 3.73 gears smart choice??
- Math guru question..how many extra miles will odometer show?
- Respond A.S.A.P - How would I tell if my tranny is broke?
- is there another 5 speed that will fit in my 99
- torque converter
- T-56
- Chirpen 3rd gear......
- Are 3.73 to steep for me?
- Enlighten me please...
- need help with trak lok
- estimate on the 1/4 mile
- Another Quick Question
- AOD/AODE Length
- shift kit
- changing clutch!
- Wrong Speedo Gear
- Help with Gear Size Please
- Steeda Tri Ax Short Shifter
- I think i messed up my clutch!
- question about gears?
- 8.8 swap w/ AL DS?
- more questions
- Clutch ?
- Problems after shift kit install...
- NavyStanger...
- New Choice For A High Power Manual Tranny!
- Help choosing which T-Lok
- gears
- spinning in reverse
- 8.8 Rear End
- Strength of Traction Lock?
- gear at the end of the 1/4 mile
- fullfully re-done!!!
- 4.10 gears w/ Trak-lok PLZ HELP
- Adjusting speedo
- where can i buy a complete rear end?
- car wont turn over in park
- Automatic Shifter?
- 3k PI Stallion Installed!!
- *ALERT* Newbie Question
- Speed in gears with different...gears.
- Searched the forums, but need answer still
- rear end axle shafts
- Launching in a '95 Manual
- Automattics are slow
- 8.8 or 7.5
- Need to buy a OD piston...
- Quick Release Clutch Quadrant question
- torque converter, is this one good
- tlock
- is installing an 8.8 axle fairly straight forward?
- installing shift kit
- Where to Get 8.8 Rearend? How much for install? Gears....
- Problem with universal joint or rear end gears
- Need new axles
- gear hp feel
- Clutch
- Have 4.10's in
- Shifter Opinions
- Hammer Shifter installation
- OMG need your help!
- Bearings shot after 65K?
- Is Tranny Shot?
- Top Speed with 4.10's
- Plans for Greatness, and some questions
- Got my new springs for teh B&M
- clutch discs made of bronze
- Installed alum. driveshaft
- Look what i found :)
- tlok and gear question
- Trans GO shift kit for my 97 auto stang
- Help I just supercharged my 96 stang..Need to know what to do to drivetrain?
- Don't understand the O/D button on the shifter?
- stock gears?
- How to convice dad to let me get 3.73's
- stalls
- Fix for long clutch pedal throw?
- Fix for long clutch pedal travel?
- Warranty and 3.73 gears
- 3.73 with NO GO!!
- Just got a Steeda Tri-Ax
- 3.73 gears installation in CA?
- 7.5" 2.73 Nloc vs. 8.8" 3.27 Tloc
- rear end strength
- A/C radiator
- Gears/ T-lok IN!!
- anyone know how fast im actually going?
- Steeda Tri-ax
- driveshaft
- what kind of tranny do i have?
- Fuel pump switch
- ATTN Tri-Ax owners! *Updated 9.23.03*
- Shift Kit and Alum. D/S
- Where can I get a good reman or repro torque converter?
- Thinking about rear end gears, need opinions
- Mainshaft spline #
- Big Question???
- got 4.10s and no chip, when will i top out???
- gears....
- Torque converter
- AODE Trans Fluid Level
- carbonfiber (drive shaft)
- Not a Mustang Question, but a Lightning question
- So, what's the deal????
- cheap gears
- rear end and gears
- shaking rear??..
- Correct Speedo Gear Information
- what year gt rear end should I use?
- 5.0 tranny swap
- update gear questionS...
- 7.5 to 8.8 carrier
- Ordered my steeda tri ax!!!
- Another TOB Question
- Anyabody else have play in their driveshaft?
- 8.8 With 4.10 Gears
- Havent been here in awhile got a question
- Whining In Second
- screeeeeeching noise!!! -help-
- Steeda Tri Ax VS Pro 5.0
- not a mustang. but a 76 cadillac eldorado( Transmission Problem??)
- Bad Tranny
- will a Fox body rear end work on my 00 v6???
- was changing tranny fluid and found this in pan.....what is it?
- Pro 5.0 = BADASS
- Tri-Ax.
- Hypothetical question... Just wondering!
- what clutch should I use if I supercharge my v6
- Shiftkit Question
- Did I break my transmission?
- Ok, one question
- Where can I get 4.10, 8.8,tlok all at one place
- gears??? 3.55?
- 99 or 00 auto tranny into a 98, what needs to be switched?
- Miles On car when clutch change
- Best aftermarket shifter
- Superior Shift kit install 300.00
- How much for gears w/ install?
- Kona shifter w/ Pro 5.0 base?
- 3.73 gears in!!!
- odometer stopped working
- HOW TO's: Tranny Cooler
- Rear dieing?
- where can i get 3.73 tlock rear end
- 4.10's with Manual
- 3.73 Gear Question
- Questions about torque converter
- POLL: gears or tlok new?!
- Dont Break Your Tlok
- Dual Tranny swap
- Anyone in search of a tranny?
- reverse
- Major Transmission Problem Please Help
- Some One Tell Me What I Just Broke
- price for 4.10 gears
- 3.73s good for .2?!?
- driveshaft
- Transgo shiftkit
- Stage 3 Clutch and Flywheels
- Triax is on its way
- '99 Automatic
- 4.10's, shift kit.
- hurst, b&m, or pro 5.0
- rebuilt tlock!
- 4r70w........
- 4r70w w/8.8 and 3.73 or 4.10
- What transmission is in my 2003 V6 Stang?
- Gefracing
- installation of stock vs adjstable clutch cable
- Will tranny work?
- if i broke my rearend....
- 4r70w
- RWD question???????
- gears and t-lock
- how necessary is a t-lok?
- tri-ax shifter with urethane gasket
- new 8.8 rearend
- clutch not engaging
- manual transmission
- Problem W/ Tranny
- HELP with my triax
- Question - 3.73 Gears
- T-5/ auto swap
- gear/tlok question & snow??
- Transmission/throwout bearing
- transmission
- Torque converter
- Will I notice a differnece if I swap my drive shaft for a aluminum one?
- Gear question
- Finally. Yes Finallyyyy gettin my superior shift kit installed tommorow
- Will the 7.5 hold?
- gears-----
- 3.73's, TLok, and Aluminum Driveshaft
- 3.73 ?? good or bad??
- Clutch question
- Looking at 4.10 gears
- 17in wheels = bad for tranny?
- Clutch related
- Think I found a place that sells the 8.8 with 4.10s
- auburn Vs. Ford t-lock
- auto tranny trouble
- 4r70w problems..HELP!!
- 99+ chiped after 3.73 effect passing smog?
- buying gears and locker
- tranny
- Speedometer recalibaration
- need some help
- How long do gears last?
- 8.8 w/ 4.10
- clutch size
- Okay need al il more help on the gears
- How much longer can I expect my clutch to last?
- broke my differential, need help asap
- How fast am i really going?
- Just Tlock and no gears?
- TC Stall Recommendation plz
- Help 8.8 swap and gear install
- I think I broke my quadrant...how are these replacements?
- Slight vibration in park
- What Tranny in 2003 V6?
- Just 4.10's and no tlok. Im cheap
- Anybody here from San Antonio, Texas? Please help!
- gears and posi
- rebuild or throw in?
- Tlock clutch/tightening (anyone have used clutch plates?)
- Clutch has too much slack...
- Question about rebulding trans price...
- PI stallion torque converters for $699!
- TRANSGO iNSTALL HELP!
- Bucking when shifting? 99+ Auto trannies
- 4R70W -VS- the AODE?
- Need Help Fast
- Gears, Driveshaft and T-Lok went in!!!
- TLok
- I finally have everything
- Converting to standard transmision?
- 4.10
- $250 for a 1990 8.8 GT rear, good deal?
- 3.73 gears????
- just got my shift kit...
- 4.10 and chip unlock limit top speed to...
|
|
vBulletin® v3.7.3, Copyright ©2000-2008, Jelsoft Enterprises Ltd.