One-touch passenger window

From 3.8Wiki

[edit] What this accomplishes

This is performed to the passenger side switch and will allow one-touch down on the passenger side though both the driver and passenger side controls.

[edit] Estimated Installation Time

10-20 minutes

[edit] Wiring Difficulty

2 / 10 - Requires little to no wiring experience

[edit] Parts Needed

- PonyPeformance one-touch module kit

OR

- (x1) OEM One-touch module

- (x2) Butt terminal connectors

- (x1) Ring terminal connector

- (x3) wire taps (only 2 needed if 99-04)

[edit] Tools Needed

- Wire Crimper

- Pliers

- Knife or scissors

- Screwdriver (99-04 to attach ground)

[edit] Instructions

Step 1

94-98, skip to step 2.

Attach the ring terminal to the end of the black wire on the module harness and crimp.

Step 2

Remove the door bezel to reveal the passenger side power window wiring.

Step 3

Use the wire tap to tap the yellow/green or blue/black (depending on harness) wire from the module harness to the blue/black or solid pink wire on the window switch.

Step 4

Use the wire tap to tap the solid yellow wire from the module harness to the yellow w/red stripe wire on the window switch.

Step 5

Locate the red w/yellow stripe wire on the window switch.

Step 6

Cut the wire and strip a little bit of insulation from the severed ends.

Step 7

Use the butt terminal on the white w/black stripe wire on the module harness to connect it to the red w/yellow stripe wire coming off the window switch. Connect the solid red wire on the module harness to the red w/yellow stripe wire going to the power window motor.

Step 8

Without a good ground (black wire), the power window 1-touch module will not properly work and the window will operate as normal. If you are having problems getting the module to work, try checking your ground.

94-98

Use the wire tap to connect the black wire from the module harness to the black wire on the window switch. (Not pictured. Please refer to steps 3 & 4 for reference to using the wire tap.)

99-04

Connect the ring terminal on the black wire on the module harness to a good ground. *Note that mine is not fully secure. I will replace this picture with one of a better ground when I fix it.*

[edit] Video

This is a video of the one-touch module in action. [1]

--Kuplex 09:47, July 3, 2007 (CDT)